Kel-Tec Sub2000 Integrated Laser Pressure Switch Modification

Kel-Tec Sub2000 Integrated Laser Pressure Switch Modification

Just when I thought I had made every modification possible, I seemed to have found yet another modification to do.

Back when I integrated my high output green SightMark laser into the handguard I made it a push button design. I did this for one main reason, the switch never work, however after realizing that I had a short in the switch itself vs. wire connection issues inside the end cap, I was able to repair the issue and put the entire pressure switch activation back in place.

The problem was that I didn't want to have a pressure switch on the side that triggered any time you set the S2K down.  After thinking long and hard, I decided to pull out the Dremel and do a recessed integrated pressure switch.  The Switch is held in place with Black High Temp Silicon.

The other little upgrade was to screw on a small piccatiny rail on the bottom of the SightMark Laser.  This was something for some gun that came with some clearance ring I purchased long ago. Although I didn't mind the flashlight mounted on the side Magpul rail, for folded storage it works better to have it under the laser.